Nissan Altima 2007-2012 Service Manual: Front washer pump
Removal and Installation
Front washer pump is not available seperately, it is part of the washer tank. Refer to WW-119, "WASHER TANK : Removal and Installation".
Washer tank
Removal and Installation REMOVAL 1. Remove the washer tank filler tube (1). 2. Remove engine under cover. 3. Position the RH fender protector back. For Sedan Refer to EXT-40, "Removal a ...Front wiper and washer switch
Removal and Installation NOTE: The wiper washer switch is part of the combination switch assembly. REMOVAL 1. Remove the spiral cable. Refer to SR-8, "Removal and Installation". 2. Di ...Other materials:
IPDM-E branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the IPDM E/R for damage, bend and loose
connection (unit side
and connector side).
Is the i ...
B1086 – B1089 seat belt pre-tensioner
LH
Description
DTC B1086 – B1089 SEAT BELT PRE-TENSIONER LH
The seat belt pre-tensioner LH is wired to the air bag diagnosis sensor unit.
The air bag diagnosis sensor unit
will monitor for opens and shorts in detected lines to the seat belt pre-tensioner
LH.
PART LOCATION
Refer to SRC-7, &qu ...
P1805 brake switch
Description
Brake switch signal is applied to the ECM through the stop lamp switch when
the brake pedal is depressed.
This signal is used mainly to decrease the engine speed when the vehicle is
driving.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATI ...