Nissan Altima 2007-2012 Service Manual: Parking brake release warning chime

System Diagram

 System Description

DESCRIPTION

• The combination meter receives the vehicle speed signal from the ABS actuator and electric unit (control unit) via CAN communication line.

• The combination meter judges whether the parking brake is released using the parking brake switch signal from the parking brake switch, and sounds the warning buzzer if necessary.

WARNING OPERATION CONDITIONS

If all of the following conditions are fulfilled

• Vehicle speed is approximately 7 km/h (4.3 MPH) or higher

• Parking brake switch ON

WARNING CANCEL CONDITIONS

Warning is canceled if any of the following conditions is fulfilled.

• Vehicle speed is approximately 3 km/h (1.9 MPH) or less

• Parking brake switch OFF

Component Parts Location

1. Combination meter M24

2. Combination switch (lighting switch) M28

3. Seat belt buckle switch LH B202

4. Door switch LH B8

5. BCM M16, M17, M18, M19 (view with instrument panel removed)

6. ABS actuator and electric unit (control unit) E26

7. Parking brake switch M73 (sedan with M/T or coupe) (view with center console removed)

8. Parking brake switch E35 (sedan with CVT) [view with instrument panel lower cover (LH) removed]

Component Description

    Seat belt warning chime
    System Diagram System Description DESCRIPTION With ignition switch turned ON and driver seat belt unfastened, seat belt warning chime will sound for approximately 6 seconds. • BCM receive ...

    Diagnosis system (meter)
    Diagnosis Description SELF-DIAGNOSIS MODE • Odo/trip meter and information display segment operation can be checked in self-diagnosis mode. • Meters/gauges can be checked in self-diagnosis ...

    Other materials:

    Fuel injector and fuel tube
    Removal and Installation 1. Fuel feed hose 2. Quick connector cap 3. Fuel tube 4. O-ring 5. Fuel damper 6. Fuel damper cap 7. Clip 8. O-ring (black) 9. Fuel injector 10. O-ring (green) A. Follow installation procedure CAUTION: • Apply new engine oil when installing the parts as spec ...

    Preparation
    Special Service Tools The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here. Commercial Service Tools ...

    Front door speaker
    Removal and Installation REMOVAL 1. Remove the front door finisher. Refer to INT-12, "Removal and Installation" (coupe) and INT-34, "Removal and Installation" (sedan). 2. Remove the front door speaker screws (A), then disconnect the front door speaker connector and remov ...