Nissan Altima 2007-2012 Service Manual: Light reminder warning chime

System Diagram

System Description

DESCRIPTION

With ignition switch in OFF or ACC position, driver door open, and lighting switch in 1ST or 2ND position, the light warning chime will sound.

• BCM detects ignition switch in OFF or ACC position, door switch LH ON, and lighting switch in 1ST or 2ND position. And then transmits buzzer output signal (light reminder warning chime) to combination meter with CAN communication line.

• When combination meter receives buzzer output signal (light reminder warning chime), it sounds the buzzer.

WARNING OPERATION CONDITIONS

If all of the following conditions are fulfilled

• Lighting switch is at 1st or 2nd position

• Ignition switch is at OFF or ACC

• Door switch LH is ON

WARNING CANCEL CONDITIONS

Warning is canceled if any of the following conditions is fulfilled.

• Lighting switch OFF

• Ignition switch ON

• Door switch LH is OFF

Component Parts Location

1. Combination meter M24

2. Combination switch (lighting switch) M28

3. Seat belt buckle switch LH B202

4. Door switch LH B8

5. BCM M16, M17, M18, M19 (view with instrument panel removed)

6. ABS actuator and electric unit (control unit) E26

7. Parking brake switch M73 (sedan with M/T or coupe) (view with center console removed)

8. Parking brake switch E35 (sedan with CVT) [view with instrument panel lower cover (LH) removed]

 Component Description

    Warning chime system
    System Diagram System Description COMBINATION METER • The buzzer (1) for warning chime system is installed in the combination meter. • The buzzer sounds when the combination meter receive ...

    Seat belt warning chime
    System Diagram System Description DESCRIPTION With ignition switch turned ON and driver seat belt unfastened, seat belt warning chime will sound for approximately 6 seconds. • BCM receive ...

    Other materials:

    P0643 Sensor power supply
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. ...

    Warning lamp
    Description • Warning lamp is built in combination meter. • Remote keyless entry system malfunction is reported to the driver by the warning lamp illumination. Component Function Check 1.CHECK FUNCTION 1. Perform “INDICATOR” in the “Active Test” mode with CONSULT-III. 2. Che ...

    Parking, license plate and tail lamps system
    Wiring Diagram - Coupe Wiring Diagram - Sedan ...