Nissan Altima 2007-2012 Service Manual: Audio antenna (sedan)

Location of Antenna

1. In-line connectors M87, M501


1. In-line connectors M87, M501

2. Audio unit harness

3. Audio unit

4. Satellite antenna

5. Audio antenna feeder

6. Satellite radio antenna feeder

7. Window Antenna

8. Antenna amp.

9. Satellite radio tuner

Window Antenna Repair

ELEMENT CHECK

1. Attach probe circuit tester (ohm setting) to antenna terminal on each side.

• When measuring continuity, wrap tin foil around the top of


• When measuring continuity, wrap tin foil around the top of probe. Then, press the foil against the wire with your finger.

• When measuring continuity, wrap tin foil around the top of


• When measuring continuity, wrap tin foil around the top of probe. Then, press the foil against the wire with your finger.

3. To locate a break, move probe along element. Tester indication


3. To locate a break, move probe along element. Tester indication will change abruptly when probe passes the broken point.

REPAIR EQUIPMENT


REPAIR EQUIPMENT

• Conductive silver composition (DuPont No. 4817 or equivalent) • Ruler 30 cm (11.8 in) long

• Drawing pen

• Heat gun

• Alcohol

• Cloth

REPAIRING PROCEDURE

1. Wipe broken heat wire and its surrounding area clean with a cloth dampened in alcohol.

2. Apply a small amount of conductive silver composition to tip of drawing pen.

Shake silver composition container before use.

3. Place ruler on glass along broken line. Deposit conductive silver composition on break with drawing pen. Slightly overlap existing heat wire on both sides [preferably 5 mm (0.20 in)] of the break.

4. After repair has been completed, check repaired wire for continuity.


4. After repair has been completed, check repaired wire for continuity.

This check should be conducted 10 minutes after silver composition is deposited.

Do not touch repaired area while test is being conducted.

5. Apply a constant stream of hot air directly to the repaired area


5. Apply a constant stream of hot air directly to the repaired area for approximately 20 minutes with a heat gun. A minimum distance of 3 cm (1.2 in) should be kept between repaired area and hot air outlet.

If a heat gun is not available, let the repaired area dry for 24 hours.

Audio, visual & navigation system bose audio without navigation


    Audio antenna (coupe)
    Location of Antenna 1. In-line connectors M87, M501 2. Audio unit harness 3. Audio unit 4. Satellite antenna 5. Audio antenna feeder 6. Satellite radio antenna feeder 7. Window Antenna 8. An ...

    Other materials:

    Monitor, climate, audio, phone and voice recognition systems
    WARNING ● Positioning of the heating or air conditioning controls and display controls should not be done while driving in order that full attention may be given to the driving operation. ● Do not disassemble or modify this system. If you do, it may result in accidents, fire, o ...

    Power window lock switch
    Description Ground circuit of main power window and door lock/unlock switch shuts off if power window lock switch of main power window and door lock/unlock switch is operated. This inhibits all operation, except for the main switch. Component Function Check 1. CHECK POWER WINDOW LOCK SIGNA ...

    B2614 ACC relay circuit
    Description BCM controls the various electrical components and simultaneously supplies power according to the power supply position. BCM checks the power supply position internally. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ...