Nissan Altima 2007-2012 Service Manual: The fuel gauge pointer does not move to "f" when refueling
Description
The fuel gauge needle will not move to “F” position when refueling.
Diagnosis Procedure
1.OBSERVE FUEL GAUGE
Does it take a long time for the pointer to move to FULL position? YES or NO
YES >> GO TO 2
NO >> GO TO 3
2.IDENTIFY FUELING CONDITION
Was the vehicle fueled with the ignition switch ON? YES or NO
YES >> Be sure to fuel the vehicle with the ignition switch OFF. Otherwise, it will take a long time to move to FULL position because of the characteristic of the fuel gauge.
NO >> GO TO 3
3.OBSERVE VEHICLE POSITION
Is the vehicle parked on an incline? YES or NO
YES >> Check the fuel level indication with vehicle on a level surface.
NO >> GO TO 4
4.OBSERVE FUEL GAUGE POINTER
During driving, does the fuel gauge pointer move gradually toward EMPTY position? YES or NO
YES >> Check the components. Refer to MWI-47, "Component Inspection".
NO >> The float arm may interfere or bind with any of the components in the fuel tank.
The fuel gauge pointer does not move
Description Fuel gauge needle will not move from a certain position. Diagnosis Procedure 1.CHECK COMBINATION METER INPUT SIGNAL 1. Select “METER/M&A” on CONSULT-III. 2. Using “FUEL M ...The oil pressure warning lamp does not turn on
Description The oil pressure warning lamp stays off when the ignition switch is turned ON. Diagnosis Procedure 1.CHECK OIL PRESSURE WARNING LAMP Perform IPDM E/R auto active test. Refer to PCS ...Other materials:
BCM (Body control module)
Diagnosis Procedure
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuse or fusible link are blown.
Is the fuse or fusible link blown?
YES >> Replace the blown fuse or fusible link after repairing the affected
circuit.
NO >> GO TO 2
2. CHECK POWER SUPPLY CIRCUIT
1. ...
Cooling fan
Description
The ECM controls the cooling fan corresponding to the vehicle speed, engine
colant temperature, refrigerant
pressure, and air conditioner ON signal. The control system has 4-step control
[HIGH/MIDDLE/LOW/OFF].
COOLING FAN MOTOR
The cooling fan operates at each speed when the cur ...
Control device
Exploded View
1. Control lever knob
2. Lock pin
3. Knob cover
4. Control device selector plate
5. Control device assembly
Removal and Installation
REMOVAL
1. Remove the center console assembly. Refer to IP-18, "Disassembly and
Assembly".
2. Disconnect the control cable from ...