Nissan Altima 2007-2012 Service Manual: AV control unit

Diagnosis Procedure

1.CHECK FUSE

Check that the following fuses of the AV control unit are not blown.

Are the fuses OK? YES >> GO TO 2

NO >> Be sure to eliminate cause of malfunction before installing new fuse.

2.CHECK POWER SUPPLY CIRCUIT

Check voltage between AV control unit harness connector and ground.

Are the voltage tests as specified? YES >> GO TO 3

NO >> Check harness between AV control unit and fuse.

3.CHECK GROUND CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect AV control unit connectors.

3. Check continuity between AV control unit harness connector M47 terminal 19 and ground.

Does continuity exist? YES >> Inspection End.

NO >> Repair harness or connector.

    Rear view camera control unit
    Diagnosis Procedure 1.CHECK FUSE Check that the following fuses of the rear view camera control unit are not blown. Are the fuses OK? YES >> GO TO 2 NO >> Be sure to eliminate ca ...

    Other materials:

    Basic inspection
    COMPONENT INSPECTION Inspection AFTER A COLLISION WARNING: Inspect all seat belt assemblies including retractors and attaching hardware after any collision. NISSAN/INFINITI recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and t ...

    P0448 evap canister vent control valve
    Description The EVAP canister vent control valve is located on the EVAP canister and is used to seal the canister vent. This solenoid valve responds to signals from the ECM. When the ECM sends an ON signal, the coil in the solenoid valve is energized. A plunger will then move to seal the c ...

    Diagnosis system (BCM)
    COMMON ITEM Diagnosis Description CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the following for all sub system selection items. ...