Nissan Altima (L32) 2007-2012 Service Manual: B1209 – b1210 collision detection
Description
DTC B1209 - B1210 COLLISION DETECTION
The air bag diagnosis sensor unit will set this DTC if it has detected a collision which has resulted in a frontal or side deployment of one or more air bags or pre-tensioners. If this DTC is detected after a SRS repair, the air bag diagnosis sensor unit has not yet been replaced. This DTC can not be erased.
PART LOCATION
Refer to SRC-7, "SRS Component Parts Location".
DTC Logic
DTC DETECTION LOGIC
With CONSULT-lll
DTC CONFIRMATION PROCEDURE (With CONSULT-lll)
1.INSPECTION START
Turn ignition switch ON.
>> GO TO 2.
2.CHECK SELF-DIAG RESULT
Check for the DTC on CONSULT-lll.
Is the DTC detected? YES >> Refer to SRC-57, "Diagnosis Procedure (Component Diagnosis)".
NO >> Inspection End.
Diagnosis Procedure (Component Diagnosis)
Refer to SR-20, "For Frontal Collision" or SR-21, "For Side and Rollover Collision".
B1017 – b1022 occupant classification system
Description DTC B1017 – B1022 OCCUPANT CLASSIFICATION SYSTEM (OCS) The occupant classification system control unit is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor u ...Ecu diagnosis
DIAGNOSIS SENSOR UNIT Wiring Diagram Trouble Diagnosis with CONSULT-III DIAGNOSTIC CODE CHART NOTE: Follow the procedures in numerical order when repairing malfunctioning pa ...Other materials:
Booster seats
Precautions on booster seats
WARNING
If a booster seat and seat belt are not used
properly, the risk of a child being injured in
a sudden stop or collision greatly
increases:
– Make sure the shoulder portion of
the belt is away from the child’s face
and neck and the lap portion of the
b ...
NVIS (Nissan vehicle immobilizer system- nats)
System Diagram
System Description
INPUT/OUTPUT SIGNAL CHART
SYSTEM DESCRIPTION
• The NVIS (NATS) is an anti-theft system by registering a keyfob ID in to
the vehicle and prevents the engine
being started by an unregistered keyfob. It has a higher protection against auto
thefts that ...
Trouble diagnosis
Condition of Error Detection
“U1000” or “U1001” is indicated on SELF-DIAG RESULTS on CONSULT-III if CAN
communication signal is
not transmitted or received between units for 2 seconds or more.
CAN COMMUNICATION SYSTEM ERROR
• CAN communication line open (CAN-H, CAN-L, or both)
• ...