Nissan Altima (L32) 2007-2012 Service Manual: BCM
Diagnosis Procedure
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuse or fusible link are blown.
Is the fuse or fusible link blown? YES >> Replace the blown fuse or fusible link after repairing the affected circuit.
NO >> GO TO 2
2. CHECK POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect BCM.
3. Check voltage between BCM harness connector and ground.
Is the measurement normal? YES >> GO TO 3
NO >> Repair or replace harness.
3. CHECK GROUND CIRCUIT
Check continuity between BCM harness connector and ground.
Does continuity exist? YES >> Inspection End.
NO >> Repair or replace harness.
Special Repair Requirement
1. REQUIRED WORK WHEN REPLACING BCM
Initialize control unit. Refer to BCS-6, "CONFIGURATION (BCM) : Special Repair Requirement".
>> Work End.
IPDM E/R (Intelligent power distribution module engine room)
Diagnosis Procedure 1. CHECK FUSES AND FUSIBLE LINK Check that the following IPDM E/R fuses or fusible link are not blown. Is the fuse blown? YES >> Replace the blown fuse or fusible ...Other materials:
P0455 evap control system
DTC Logic
DTC DETECTION LOGIC
This diagnosis detects a very large leak (fuel filler cap fell off etc.) in
EVAP system between the fuel tank and
EVAP canister purge volume control solenoid valve.
CAUTION:
• Use only a genuine NISSAN fuel filler cap as a replacement. If an incorrect
fu ...
AV Branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the AV control unit for damage, bend
and loose connection (unit
side and connector side).
I ...
Making a call
1. Press thebutton on the Launch
Bar.
The "Phone" screen will appear on the
display.
2. Select one of the options to make a call.
Phonebook
To access the phonebook:
1. Press thebutton on the
steering
wheel or touch the "" key on the
launch bar.
2. Touch the "Phonebook" key.
3. Choose the desir ...