Nissan Altima (L32) 2007-2012 Service Manual: Combination meter
Diagnosis Procedure
1.CHECK FUSES
Check for blown combination meter fuses.
Is the inspection result normal? YES >> GO TO 2
NO >> If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.
2.POWER SUPPLY CIRCUIT CHECK
1. Disconnect combination meter connector.
2. Check voltage between combination meter harness connector M24 terminals 1, 2, 14 and ground.
Is the inspection result normal? YES >> GO TO 3
NO >> Check harness for open between combination meter and fuse.
3.GROUND CIRCUIT CHECK
1. Turn ignition switch OFF.
2. Check continuity between combination meter harness connector terminals 3, 4, 23 and ground.
Is the inspection result normal? YES >> Inspection End.
NO >> Check ground harness.
BCM (Body control module)
Diagnosis Procedure
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuse or fusible link are blown.
Is the fuse or fusible link blown?
YES >> Replace the blown fuse or fusible li ...
Other materials:
Vehicle security system
System Diagram
System Description
INPUT/OUTPUT SIGNAL CHART
OPERATION FLOW
SETTING THE VEHICLE SECURITY SYSTEM
Initial Condition
• Ignition switch is in OFF position.
Disarmed Phase
• When doors or trunk is open, the vehicle security system is set in the
disarmed phase on the ass ...
Oil cooler
Removal and Installation
1. Oil pressure switch
2. Oil cooler
3. Gasket
4. Water hose (outlet)
5. Water hose (inlet)
A. To water control valve housing
B. To heater pipe assembly
C. Hose clamp
D. Clip
WARNING:
Be careful not to get burned, engine coolant and engine oil may be hot.
CAUTI ...
Road test
Description
DESCRIPTION
• The purpose of the test is to determine overall performance of CVT
and analyze causes of problems.
• The road test consists of the following three parts:
1. “Check Before Engine Is Started” TM-249.
2. “Check at Idle” TM-250.
3. “Cruise Test” TM- ...
