Nissan Altima 2007-2012 Service Manual: Combination switch output circuit

Diagnosis Procedure

1. CHECK OUTPUT 1 - 5 SYSTEM CIRCUIT FOR OPEN

1. Turn the ignition switch OFF.

2. Disconnect the BCM and combination switch.

3. Check continuity between BCM harness connector and combination switch harness connector.

Does continuity exist? YES >> GO TO 2

NO >> Repair or replace harness.

2. CHECK OUTPUT 1 - 5 SYSTEM CIRCUIT FOR SHORT

Check for continuity between BCM harness connector and ground.

Does continuity exist? YES >> Repair or replace harness.

NO >> GO TO 3

3. CHECK COMBINATION SWITCH OUTPUT VOLTAGE

1. Connect the BCM and combination switch.

2. Turn ON any switch in the system that is malfunctioning.

3. Check voltage between combination switch harness connector and ground.

Is the measurement normal when any of the switches is turned ON? YES >> Replace BCM. Refer to BCS-96, "Removal and Installation".

NO >> Replace the combination switch. Refer to WW-121, "Removal and Installation".

Special Repair Requirement

1. REQUIRED WORK WHEN REPLACING BCM

Initialize control unit. Refer to BCS-6, "CONFIGURATION (BCM) : Special Repair Requirement".

>> Work End.

    Combination switch input circuit
    Diagnosis Procedure 1. CHECK INPUT 1 - 5 SYSTEM CIRCUIT FOR OPEN 1. Turn the ignition switch OFF. 2. Disconnect the BCM and combination switch. 3. Check continuity between BCM harness connect ...

    ECU diagnosis
    BCM (BODY CONTROL MODULE) Reference Value VALUES ON THE DIAGNOSIS TOOL Terminal Layout Physical Values 1: Sedan only 2: With LH front window a ...

    Other materials:

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the dr ...

    Multi av system (sedan)
    System Diagram System Description The multi AV system consists of the following systems. • Navigation system • Audio system • Rear view monitor • Hands-free phone system Refer to the following table for multi AV system descriptions. VOICE RECOGNITION The multi AV system uses v ...

    IPDM E/R (Intelligent power distribution module engine room)
    Diagnosis Procedure 1. CHECK FUSES AND FUSIBLE LINK Check that the following IPDM E/R fuses or fusible link are not blown. Is the fuse blown? YES >> Replace the blown fuse or fusible link after repairing the affected circuit. NO >> GO TO 2 2. CHECK POWER SUPPLY CIRCUIT 1. Tu ...