Nissan Altima 2007-2012 Service Manual: Precautions in repairing high strength steel

High Strength Steel (HSS)

High strength steel is used for body panels in order to reduce vehicle weight.

Accordingly, precautions in repairing automotive bodies made of high strength steel are described below:

SP130 is the most commonly used HSS.

Read the following precautions when repairing HSS: 1. Additional points to consider

• The repair of reinforcements (such as side members) by heating is not recommended since it may weaken the component.

When heating is unavoidable, do not heat HSS parts above 550°C (1,022°F).

Verify heating temperature with a thermometer.

(Crayon-type and other similar type thermometer are appropriate.)

• When straightening body panels, use caution in pulling any HSS panel. Because HSS is very strong, pulling may cause deformation in adjacent portions of the body. In this case, increase the number of measuring points, and carefully pull the HSS panel.

• When cutting HSS panels, avoid gas (torch) cutting if possible.

Instead, use a saw to avoid weakening surrounding areas due to heat. If gas (torch) cutting is unavoidable, allow a minimum margin of 50 mm (1.97in).

• When welding HSS panels, use spot welding whenever possible in order to minimize weakening surrounding areas due to heat.

If spot welding is impossible, use M.I.G. welding. Do not use gas (torch) welding because it is inferior in welding strength.

• The spot weld on HSS panels is harder than that of an ordinary steel panel.

Therefore, when cutting spot welds on a HSS panel, use a low speed high torque drill (1,000 to 1,200 rpm) to increase drill bit durability and facilitate the operation.

2. Precautions in spot welding HSS

This work should be performed under standard working conditions.

Always note the following when spot welding HSS: • The electrode tip diameter must be sized properly according to the metal thickness.

• The panel surfaces must fit flush to each other, leaving no gaps.

• Follow the specifications for the proper welding pitch.

    Body alignment
    Body Center Marks A mark has been placed on each part of the body to indicate the vehicle center. When repairing parts damaged by an accident which might affect the vehicle frame (members, pillar ...

    Replacement operations
    Description This section is prepared for technicians who have attained a high level of skill and experience in repairing collision- damaged vehicles and also use modern service tools and equipmen ...

    Other materials:

    BCM (Body control module)
    Reference Value VALUES ON THE DIAGNOSIS TOOL Terminal Layout Physical Values 1: Sedan only 2: With LH front window anti-pinch 3: With LH and RH front window anti-pinch 4: With Intelligent Key 5: Without Intelligent Key Wiring Diagram-Coupe ...

    Shift lock system
    Description The selector lever cannot be shifted from “P” position to any other position unless the ignition switch is in the ON position and the brake pedal is depressed. Wiring Diagram - CVT SHIFT LOCK SYSTEM - Coupe Wiring Diagram - CVT SHIFT LOCK SYSTEM - Sedan Diagnosi ...

    B2191, P1615 Difference of key
    Description Performs ID verification through BCM and keyfob when push-button ignition switch is pressed. Prohibits the release of steering lock or start of engine when an unregistered ID of keyfob is used. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRM ...