Nissan Altima Owners Manual: BSW/LDW temporary disabled status

Under the following condition, the BSW and/or LDW system is turned off temporarily, the BSW light (white) and/or LDW light (white) will blink, and either of the following message will appear in the vehicle information display:

● Trunk is open ● Washer fluid is low

When the above conditions are corrected, the BSW and/or LDW system will resume automatically.

    LDW system operation
    The LDW system operates above approximately 45 MPH (70 km/h). When the vehicle approaches either the left or the right of the traveling lane, the LDW system will chime a sound and the LDW light ...

    BSW/LDW automatic deactivation
    When dirt, rain or snow cannot be removed by the automatic washer and blower and accumulates on the camera, making it impossible to detect the vehicles or the lane markers, the BSW and/or LDW syst ...

    Other materials:

    Camera on signal circuit (coupe)
    Description When the selector lever is placed in the R position, the rear view camera control unit sends a camera ON signal to the rear view camera. Diagnosis Procedure 1.CHECK CAMERA ON SIGNAL CIRCUIT CONTINUITY 1. Turn ignition switch OFF. 2. Disconnect rear view camera control unit con ...

    B2192, P1611 ID discord, IMMU-ECM
    Description BCM performs the ID verification with ECM that allows the engine to start. Start the engine if the ID is OK. ECM prevents the engine from starting if the ID is not registered. BCM starts the communication with ECM if ignition switch is turned ON. DTC Logic DTC DETECTION LOGIC ...

    Evaporator
    Removal and Installation COMPONENTS 1. Heater and cooling unit case 2. Evaporator 3. Intake sensor 4. In-cabin microfilter 5. Evaporator cover 6. Heater and cooling unit foot duct RH 7. Blower unit REMOVAL 1. Remove the heater and cooling unit assembly. Refer to HA-32, "HFC-134a ...