Nissan Altima (L32) 2007-2012 Service Manual: Steering switch
Removal and Installation
REMOVAL
1. Remove the driver airbag module. Refer to SR-5, "Removal and
Installation".
2. Remove the steering wheel switch assembly screws (A), then
remove the steering wheel switches (1).
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
REMOVAL
1. Lower the headliner at the rear. Refer to INT-20, "Removal and
Installation" (coupe) and INT-42,
"Removal and Installation" (sedan).
2. ...
Removal and Installation - Coupe
REMOVAL
1. Remove the rear pillar finisher RH. Refer to INT-15, "Removal and
Installation".
2. Detach the antenna amp harness clip (B), disconnect th ...
Other materials: Instrument panel
Vents
Steering wheel switches for audio control*
Vehicle information display controls
Headlight/turn signal switch
Paddle shifters (if so equipped)
Driver supplemental air bag
Horn
Meters and gauges
Warning and indicator lights
Vehicle information display
Wiper and washer switch
Heat ...
Seat belt extenders
If, because of body size or driving position, it
is not possible to properly fit the lap/
shoulder belt and fasten it, an extender
that is compatible with the installed seat
belts is available for purchase. The extender
adds approximately 8 in (200 mm)
of length and may be used for either the
driver ...
LATCH (Lower Anchors and Tethers for
CHildren) system
LATCH system anchor locations
Your vehicle is equipped with special anchor
points that are used with LATCH system
compatible child restraints. This system
may also be referred to as the ISOFIX
or ISOFIX compatible system. With this system,
you do not have to use a vehicle seat
belt to secure the ch ...