Nissan Altima 2007-2012 Service Manual: On-vehicle repair
HORN
Removal and Installation
REMOVAL
1. Position aside the front fender protector LH. Refer to EXT-19, "Removal and Installation".
2. Disconnect the horn connectors (A).
3. Remove the horn bracket bolt (B), and remove horn (1) and horn (2) if equipped.
INSTALLATION
Installation is in the reverse order of removal.
Component diagnosis
Wiring Diagram - Coupe Wiring Diagram - Sedan ...Power Outtlet
...Other materials:
B2109 steering lock relay
Description
The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN
communication.
IPDM E/R turns the steering lock relay ON and transmits the release of the
steering to BCM.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2109 is displayed with DTC U1000, first perf ...
B1113 – B1115 satellite sensor RH
Description
DTC B1113 – B1115 SATELLITE SENSOR RH
The satellite sensor RH is wired to the air bag diagnosis sensor unit. The
air bag diagnosis sensor unit will
monitor the satellite sensor RH for internal failures and it's circuits for
communication errors.
PART LOCATION
Refer to SRC-7, & ...
Microphone signal circuit (coupe)
Description
Voice signals are transmitted from the microphone to the Bluetooth control
unit using the microphone signal
circuits.
Diagnosis Procedure
1.CHECK HARNESS BETWEEN BLUETOOTH CONTROL UNIT AND MICROPHONE
1. Turn ignition switch OFF.
2. Disconnect Bluetooth control unit connector a ...