Nissan Altima (L32) 2007-2012 Service Manual: BCM (Body control module)
Diagnosis Procedure
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuse or fusible link are blown.
Is the fuse or fusible link blown? YES >> Replace the blown fuse or fusible link after repairing the affected circuit.
NO >> GO TO 2
2. CHECK POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect BCM.
3. Check voltage between BCM harness connector and ground.
Is the measurement normal? YES >> GO TO 3
NO >> Repair or replace harness.
3. CHECK GROUND CIRCUIT
Check continuity between BCM harness connector and ground.
Does continuity exist? YES >> Inspection End.
NO >> Repair or replace harness.
Special Repair Requirement
1. REQUIRED WORK WHEN REPLACING BCM
Initialize control unit. Refer to BCS-6, "CONFIGURATION (BCM) : Special Repair Requirement".
>> Work End.
Combination meter
Diagnosis Procedure 1.CHECK FUSES Check for blown combination meter fuses. Is the inspection result normal? YES >> GO TO 2 NO >> If fuse is blown, be sure to eliminate cause ...IPDM E/R (Intelligent power distribution module engine room)
Diagnosis Procedure 1. CHECK FUSES AND FUSIBLE LINK Check that the following IPDM E/R fuses or fusible link are not blown. Is the fuse blown? YES >> Replace the blown fuse or fusible link ...Other materials:
Magnet clutch
Description
SYSTEM DESCRIPTION
Front air control controls A/C compressor operation by ambient temperature
and signal from ECM.
Low Temperature Protection Control
Front air control will turn the A/C compressor ON or OFF as determined
by a signal detected by ambient sensor.
When ambient te ...
Towing your vehicle
When towing your vehicle, all State (Provincial in
Canada) and local regulations for towing must be
followed. Incorrect towing equipment could damage
your vehicle. Towing instructions are available
from a NISSAN dealer. Local service operators
are generally familiar with the applicable laws
an ...
Ecu diagnosis
ECM
Reference Value
VALUES ON THE DIAGNOSIS TOOL
Remarks:
● Specification data are reference values.
● Specification data are output/input values
which are detected or supplied by the ECM at the connector.
* Specification data may not be directly related to their components ...