Nissan Altima 2007-2012 Service Manual: Roof side molding
Removal and Installation
1. Body side outer panel
2. Windshield
2. Windshield
REMOVAL
1. Lift and twist the roof side molding up from the rear edge.
2. Disconnect the roof side molding from the clips, and remove the roof side molding.
INSTALLATION
Installation is in the reverse order of removal.
• Engage the roof molding into the clips starting at the rear.
Drip molding
Removal and Installation REMOVAL 1. Using a trim stick or equivalent, disconnect the drip mouldings starting at the front, working rearward. 2. Remove the drip moldings. INSTALLATION Ins ...License lamp finisher
Removal and Installation 1. License lamp finisher REMOVAL 1. Remove the trunk lid finisher (if equipped). Refer to INT-22, "Exploded View". 2. Remove the license lamp finisher nuts ...Other materials:
Front seat belt
Exploded View
1. D-ring anchor
2. Adjuster cover
3. Outer anchor bolt cover
4. Seat belt pre-tensioner connector
5. Seat belt retractor
6. Seat belt adjuster
A. D-ring anchor bolt
B. Outer anchor bolt
C. Retractor screw
D. Retractor anchor bolt
E. Bolt
1. Seat belt retractor
2. Se ...
Headlamp (xenon)
Description
The IPDM E/R (intelligent power distribution module engine room) controls the
headlamp low relay based on
inputs from the BCM over the CAN communication lines. When the headlamp low
relay is energized, power
flows through fuses 51 and 52, located in the IPDM E/R. Power then ...
Key slot illumination
Description
Blinks when Intelligent Key insertion is required.
Component Function Check
Check key slot illumination (“KEY SLOT ILLUMI”) Active Test mode.
Is the inspection result normal?
YES >> Key slot function is OK.
NO >> Refer to SEC-114, "Diagnosis Procedure&q ...