Nissan Altima 2007-2012 Service Manual: Front wiper drive assembly

Removal and Installation

REMOVAL

1. Operate front wiper motor, and stop at the auto stop position.

2. Remove wiper arms. Refer to WW-116, "FRONT WIPER ARMS : Removal and Installation".

3. Remove the cowl top cover. For Sedan Refer to EXT-39, "Removal and Installation". For Coupe Refer to EXT-18, "Removal and Installation".

4. Remove the strut brace bolts (A), detach the wiper drive assembly harness clips, then remove the strut brace (1).

5. Detach the wiper drive harness clip from the wiper drive assembly frame.

6. Remove the front wiper drive assembly bolts (A), disconnect the wiper drive motor connector (B) and remove the front wiper drive assembly (1).

INSTALLATION

1. Install the front wiper drive assembly.

2. Connect wiper motor connector. Turn wiper switch ON to operate wiper motor, then turn wiper switch OFF (auto stop).

3. Attach the wiper drive harness clip to the wiper drive assembly frame.

4. Install the strut brace, then attach the wiper drive assembly harness clips.

5. Install the cowl top cover. For Sedan Refer to EXT-39, "Removal and Installation". For Coupe Refer to EXT-18, "Removal and Installation" 6. Attach the wiper arms. Refer to WW-116, "FRONT WIPER ARMS : Removal and Installation".

7. Adjustment of wiper arm stop location. Refer to WW-116, "FRONT WIPER ARMS : Removal and Installation".

    Front wiper ARMS
    Removal and Installation REMOVAL 1. Turn wiper switch ON to operate wiper motor, and then turn wiper switch OFF (auto stop). 2. Open hood, remove arm caps, and remove wiper arm nuts. 3. Rais ...

    Other materials:

    Symptom diagnosis
    SQUEAK AND RATTLE TROUBLE DIAGNOSES Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs.Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any customer's ...

    Multiport fuel injection system
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: This sensor is not used to control the engine system under normal conditions. *2: This signal is sent to the ECM through CAN communication line. *3: ECM determines the start signal status by the signals of engine speed and ...

    Can communication circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connectors on CAN communication system. 4. Check terminals and connectors for damage, bend and loose con ...