Nissan Altima 2007-2012 Service Manual: Condenser

Removal and Installation - Coupe

REMOVAL

1. Remove the rear seat cushion and the rear seatback.

Refer to SE-25, "Removal and Installation".

2. Remove the rear kicking plate, rear wheel well garnish and the rear pillar finisher.

Refer to INT-19, "Removal and Installation".

3. Disconnect the connectors (A), remove bolt (B), and then remove condenser (1) from the vehicle body.

INSTALLATION


INSTALLATION

Installation is in the reverse order of removal.

Removal and Installation - Sedan

REMOVAL

1. Remove the rear seat cushion and the rear seatback.

Refer to SE-53, "Removal and Installation".

2. Remove the rear kicking plate, rear wheel well garnish and the rear pillar finisher.

Refer to INT-36, "Removal and Installation".

3. Disconnect the electrical connector, remove bolt (A), and then remove condenser (1) from the vehicle body.

INSTALLATION


INSTALLATION

Installation is in the reverse order of removal.

    Filament
    Inspection and Repair INSPECTION 1. When measuring voltage, wrap tin foil around the top of the negative probe. Then press the foil against the wire with your finger. 2. Attach probe circuit tes ...

    Horn
    ...

    Other materials:

    Driving the vehicle
    CONTINUOUSLY VARIABLE TRANSMISSION (CVT) WARNING ● Do not depress the accelerator pedal while shifting from P (Park) or N (Neutral) to R (Reverse), D (Drive), Ds (Drive Sport) or manual shift mode (if so equipped). Always depress the brake pedal until shifting is completed. Failure to ...

    Auto operation does not operate but manual operates normally (driver side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-190, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement". Is the inspection result normal? YES >> GO TO 2 NO >> Repair or replace the ma ...

    Spark plug
    Removal and Installation 1. Ignition coil 2. Spark plug 3. Rocker cover RH 4. Rocker cover LH REMOVAL 1. Remove the ignition coil. Refer to EM-145, "Removal and Installation LH" and EM-145, "Removal and Installation RH". 2. Remove the spark plug with a suitable spar ...