Nissan Altima 2007-2012 Service Manual: Rear bumper
Removal and Installation
1. Rear bumper supports
2. Rear bumper reinforcement
3. Energy absorbing foam
4. Splash shield LH
5. Rear bumper fascia
6. Splash shield RH
REMOVAL
1. Remove the LH and RH rear combination lamps. Refer to EXL-260, "Removal and Installation".
2. Remove both the rear wheels and tires. Refer to WT-66, "Adjustment".
3. Remove the LH and RH splash shields.
4. Remove the rear bumper fascia clips and screws, then remove the rear bumper fascia.
5. Remove the rear energy absorbing foam.
6. Remove the rear bumper reinforcement.
7. Remove the rear bumper supports.
INSTALLATION
Installation is in the reverse order of removal.
Front bumper
Removal and Installation 1. Front bumper supports 2. Front bumper reinforcement 3. Energy absorbing foam 4. Tow cover 5. Front grille 6. Engine under cover 7. Fog lamp finisher (if equipped) ...Front grille
Removal and Installation 1. Front grille 2. Bumper fascia FRONT GRILLE Removal 1. Remove the front grille clips. 2. Release the grille tabs from the front bumper fascia, then remove the ...Other materials:
Key slot illumination
Description
Blinks when Intelligent Key insertion is required.
Component Function Check
Check key slot illumination (“KEY SLOT ILLUMI”) Active Test mode.
Is the inspection result normal?
YES >> Key slot function is OK.
NO >> Refer to SEC-114, "Diagnosis Procedure&q ...
Positive crankcase ventilation
Description
This system returns blow-by gas to the intake manifold.
The positive crankcase ventilation (PCV) valve is provided to conduct crankcase
blow-by gas to the intake
manifold.
During partial throttle operation of the engine, the intake manifold sucks the
blow-by gas through th ...
Microphone
Diagnosis Procedure
1.CHECK POWER SUPPLY CIRCUIT (MICROPHONE SIDE)
Check voltage between microphone harness connector and ground.
Is proper voltage present?
YES >> GO TO 4
NO >> GO TO 2
2.CHECK POWER SUPPLY CIRCUIT (CONTINUITY)
1. Turn ignition switch OFF.
2. Disconnect mic ...