Nissan Altima (L32) 2007-2012 Service Manual: Drip molding
Removal and Installation
REMOVAL
1. Using a trim stick or equivalent, disconnect the drip mouldings starting at the front, working rearward.
2. Remove the drip moldings.
INSTALLATION
Installation is in the reverse order of removal.
• Insert drip moldings onto vehicle starting at the rear, working forward.
Door outside molding
Removal and Installation 1. Front door outside molding 2. Rear door outside molding Front Door Outside Molding Removal 1. Open the front door window fully. 2. Remove the side view mirror. ...Roof side molding
Removal and Installation 1. Body side outer panel 2. Windshield 2. Windshield REMOVAL 1. Lift and twist the roof side molding up from the rear edge. 2. Disconnect the roof side molding ...Other materials:
Differential side oil seal
Exploded View
1. Transaxle assembly
2. Differential side oil seal
Removal and Installation
REMOVAL
1. Remove drive shaft assembly. Refer to FAX-11, "Removal and
Installation (Left Side)" and FAX-12, "Removal and Installation
(Right Side)".
2. Remove the differential ...
Service data and specifications
(SDS)
Idle Speed
*: Under the following conditions
• A/C switch: OFF
• Electric load: OFF (Lights, heater fan & rear window defogger)
• Steering wheel: Kept in straight-ahead position
Ignition Timing
*: Under the following conditions
• A/C switch: OFF
• Electric load: OFF (Ligh ...
P0101 Maf sensor
Description
The mass air flow sensor (1) is placed in the stream of intake air. It
measures the intake flow rate by measuring a part of the entire
intake flow. The mass air flow sensor controls the temperature of the
hot wire to a certain amount. The heat generated by the hot wire is
reduced as ...