Nissan Altima 2007-2012 Service Manual: Front wiper auto stop signal circuit

Component Function Check

1. CHECK FRONT WIPER (AUTO STOP) OPERATION

1. Select "FRONT WIPER STOP" of IPDM E/R DATA MONITOR item.

2. Operate the front wiper.

3. With the front wiper operation, check the monitor status.

Is the status of item normal? YES >> Auto stop signal circuit is normal.

NO >> Refer to WW-24, "Diagnosis Procedure".

Diagnosis Procedure

1. CHECK FRONT WIPER MOTOR (AUTO STOP) OUTPUT VOLTAGE

1. Turn the ignition switch OFF.

2. Disconnect front wiper motor.

3. Turn the ignition switch ON.

4. Check voltage between IPDM E/R harness connector and ground.

Is the measurement normal? YES >> GO TO 2

NO >> Replace IPDM E/R. Refer to PCS-48, "Removal and Installation".

2. CHECK FRONT WIPER MOTOR (AUTO STOP) CIRCUIT CONTINUITY

1. Turn the ignition switch OFF.

2. Disconnect IPDM E/R.

3. Check continuity between IPDM E/R harness connector (A) and front wiper motor harness connector (B).

Does continuity exist? YES >> GO TO 3

NO >> Repair or replace harness.

3. CHECK FRONT WIPER MOTOR (AUTO STOP) SHORT CIRCUIT

Check continuity between IPDM E/R harness connector and ground.

Does continuity exist? YES >> Repair or replace harness.

NO >> Replace front wiper motor. Refer to WW-116, "FRONT WIPER DRIVE ASSEMBLY : Removal and Installation".

    Front wiper motor hi circuit
    Component Function Check 1. CHECK FRONT WIPER HI OPERATION 1. Start IPDM E/R auto active test. Refer to PCS-14, "Diagnosis Description". 2. Check that the front wiper operates at the ...

    Front wiper motor ground circuit
    Diagnosis Procedure 1.CHECK FRONT WIPER MOTOR (GND) OPEN CIRCUIT 1. Turn the ignition switch OFF. 2. Disconnect front wiper motor. 3. Check continuity between front wiper motor harness connec ...

    Other materials:

    Can communication circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connectors on CAN communication system. 4. Check terminals and connectors for damage, bend and loose con ...

    Service data and specifications(SDS)
    Wheel Alignment (Unladen*) Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions. Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions. Ball Joint Wheelarch Height (Unladen*1) ...

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the dr ...