Nissan Altima (L32) 2007-2012 Service Manual: Push button ignition switch
Removal and Installation
REMOVAL
1. Remove the cluster lid A assembly. Refer to IP-12, "Removal and Installation".
2. Release the pawls (A) and remove the push-button ignition switch (1) from cluster lid A.
INSTALLATION
Installation is in the reverse order of removal.
BCM (Body control module)
Removal and Installation For removal and installation of the BCM refer to BCS-96, "Removal and Installation". ...Charging system
...Other materials:
Front wiper auto stop signal circuit
Component Function Check
1. CHECK FRONT WIPER (AUTO STOP) OPERATION
1. Select "FRONT WIPER STOP" of IPDM E/R DATA MONITOR item.
2. Operate the front wiper.
3. With the front wiper operation, check the monitor status.
Is the status of item normal?
YES >> Auto stop signal ...
Line pressure test
Inspection and Judgment
INSPECTION
Line Pressure Test Port (A)
Line Pressure Test Procedure
1. Inspect the amount of engine oil and replenish if necessary.
2. Drive the car for about 10 minutes to warm it up so that the CVT fluid
reaches in the range of 50 to 80°C
(122 to 176°F), then ...
Variable induction air system
System Diagram
System Description
INPUT/OUTPUT SIGNAL CHART
*: ECM determines the start signal status by the signals of engine speed and
battery voltage.
SYSTEM DESCRIPTION
In the medium speed range, the ECM sends the ON signal to the VIAS control
solenoid valve. This signal
introdu ...