Nissan Altima 2007-2012 Service Manual: On-vehicle repair
COMBINATION METER
Removal and Installation
REMOVAL
1. Open the fuse block cover, remove the instrument lower cover screw (A), then remove the instrument lower cover (1).
• Disconnect the harness connectors.
• Disconnect the aspirator tube.
2. Remove the steering column screws (A), then remove both the steering wheel column upper (1) and lower (2) covers.
NOTE: • Turn steering wheel to access steering column cover screws.
• Steering wheel removed for clarity.
3. Remove the cluster lid A (1).
NOTE: Steering wheel removed for clarity.
4. Remove the combination meter screws (A) using power tools, and pull out the combination meter (1).
5. Disconnect the combination meter connector, and remove the combination meter (1).
INSTALLATION
Installation is in the reverse order of removal.
Precaution
Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used alo ...Disassembly and assembly
COMBINATION METER Disassembly and Assembly DISASSEMBLY 1. Remove the combination meter. Refer to IP-12, "Removal and Installation". 2. Remove the combination meter lens (1) from the co ...Other materials:
P2127, P2128 APP Sensor
Description
The accelerator pedal position sensor is installed on the upper end
of the accelerator pedal assembly. The sensor detects the accelerator
position and sends a signal to the ECM.
Accelerator pedal position sensor has two sensors. These sensors
are a kind of potentiometers which tr ...
Seat belts with pretensioners (Front seats)
WARNING
● The pretensioners cannot be reused after
activation. They must be replaced
together with the retractor and buckle
as a unit.
● If the vehicle becomes involved in a
collision but a pretensioner is not activated,
be sure to have the pretensioner
system checked and, if nec ...
Ignition signal
Description
The ignition signal from the ECM is sent to and amplified by the power
transistor. The power transistor turns
ON and OFF the ignition coil primary circuit. This ON/OFF operation induces the
proper high voltage in the coil
secondary circuit.
Component Function Check
1.INSPECTION ...