Nissan Altima 2007-2012 Service Manual: Front grille

Removal and Installation

1. Front bumper fascia


1. Front bumper fascia

2. Front grille

3. License plate bracket

4. Fog lamp finisher (if equipped)

5. Fog lamp (if equipped)

A. Clip C101

Removal

1. Remove the front fender protectors RH and LH. Refer to EXT-19, "Removal and Installation".

2. Remove the engine under cover.

3. Remove the RH and LH side under covers.

4. Remove the front bumper fascia clips and screws, then remove the front bumper fascia.

5. Remove the fog lamp if equipped. Refer to EXL-256, "Removal and Installation".

6. Release the grille tabs from the front bumper fascia and remove the front grille.

Installation

Installation is in the reverse order of removal.

    Rear bumper
    Removal and Installation 1. Rear bumper side brackets 2. Rear bumper supports 3. Rear bumper reinforcement 4. Rear energy absorbing foam 5. Rear bumper fascia A. C205 push pin REMOVAL 1. R ...

    Cowl top
    Removal and Installation 1. Cowl top seal 2. Cowl top side trim covers 3. Cowl top foam blocks 4. Cowl top A. Clips REMOVAL 1. Remove both the RH and LH wiper arms. Refer to WW-116, "FRO ...

    Other materials:

    P1572 ASCD brake switch
    Description When the brake pedal is depressed, ASCD brake switch is turned OFF and stop lamp switch is turned ON. ECM detects the state of the brake pedal by this input of two kinds (ON/OFF signal). Refer to EC-67, "System Description" for the ASCD function. DTC Logic DTC DET ...

    Microphone
    Removal and Installation REMOVAL 1. Remove the room/map lamp assembly. Refer to INL-121, "Removal and Installation". 2. Detach the microphone connector (A). 3. Remove the map lamp covers (1), then remove the map lamp assembly cover (2). 4. Release the microphone tabs (A), th ...

    Tweeter (sedan)
    Description The audio unit sends audio signals to the tweeters using the door speaker circuits. Diagnosis Procedure 1.HARNESS CHECK 1. Disconnect audio unit connector M43 (A) and suspect tweeter connector (B). 2. Check continuity between audio unit harness connector M43 (A) and suspect t ...