Nissan Altima 2007-2012 Service Manual: Front power window switch

Reference Value

TERMINAL LAYOUT

PHYSICAL VALUES


PHYSICAL VALUES

POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH


Wiring Diagram


Wiring Diagram








Fail Safe


Fail Safe

FAIL-SAFE CONTROL

Switches to fail-safe control when malfunction is detected in encoder signal that detects up/down speed and direction of door glass. Switches to fail-safe control when error beyond regulation value is detected between the fully closed position and the actual position of the glass.

It changes to condition before initialization and the following functions do


It changes to condition before initialization and the following functions do not operate when switched to failsafe control.

    Power window main switch
    Reference Value TERMINAL LAYOUT PHYSICAL VALUES MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH Wiring Diagram Fail Safe FAIL-SAFE CONTROL Switches to fail-safe control wh ...

    BCM (Body control module)
    Reference Value VALUES ON THE DIAGNOSIS TOOL Terminal Layout Physical Values 1: Sedan only 2: With LH front window anti-pinch 3: With LH and RH f ...

    Other materials:

    Additional service when replacing control unit
    Description When replacing ECM, this procedure must be performed. Special Repair Requirement 1.PERFORM INITIALIZATION OF NATS SYSTEM AND REGISTRATION OF ALL NATS IGNITION KEY IDS Refer to SEC-15, "ECM RE-COMMUNICATING FUNCTION : Special Repair Requirement" (Coupe) or SEC- 214, &qu ...

    Cowl top
    Removal and Installation 1. Cowl top seal 2. Cowl top side trim covers 3. Cowl top foam blocks 4. Cowl top A. Clips REMOVAL 1. Remove both the RH and LH wiper arms. Refer to WW-116, "FRONT WIPER ARMS : Removal and Installation". 2. Remove the cowl top side trim covers. 3. ...

    Input shaft and gear
    Exploded View Refer to TM-28, "Exploded View". Disassembly 1. Before disassembling, measure end play for 3rd, 4th, 5th, and 6th input gears. End play standard value : Refer to TM-83, "End Play". 2. Remove oil channel. 3. Press out input shaft rear bearing using Tool an ...