Nissan Altima (L32) 2007-2012 Service Manual: Additional service when removing battery negative terminal
Description
Initial setting is necessary when battery terminal is diconnected. CAUTION: The following specified operations are not performed under the non-initialized condition.
• Auto-up operation
• Anti-pinch function
• Retained power operation
Special Repair Requirement
INITIALIZATION PROCEDURE
1. Disconnect battery negative terminal or main power window and door lock/unlock switch. Reconnect it after a minute or more.
2. Turn ignition switch ON.
3. Operate power window switch to fully open the window. (This operation is unnecessary if the window is already fully open) 4. Continue pulling the power window switch UP (AUTO-UP operation). Even after glass stops at fully closed position, keep pulling the switch for 4 seconds or more.
5. Inspect anti-pinch function.
CHECK ANTI-PINCH FUNCTION
1. Fully open the door window.
2. Place a piece of wood near fully closed position.
3. Close door glass completely with AUTO-UP.
• Check that glass lowers for approximately 150 mm or 2 seconds without pinching piece of wood and stops.
• Check that glass does not rise when operating the power window main switch while lowering.
CAUTION: • Do not check with hands and other part of body because they may be pinched. Do not get pinched.
• Check that AUTO-UP operates before inspection when system initialization is performed.
• It may switch to fail-safe mode if open/close operation is performed continuously. Perform initial setting in that situation. Refer to PWC-42, "Fail Safe".
• Perform initial setting when auto-up operation or anti-pinch function does not operate normally.
• Finish initial setting. Otherwise, next operation cannot be done.
1. Auto-up operation
2. Anti-pinch function
3. Retained power operation when ignition switch is OFF.
Additional service when replacing control unit
Description Initial setting is necessary when replacing main power window and door lock/unlock switch. CAUTION: The following specified operations are not performed under the non-initialized c ...Other materials:
Intelligent Driver Alertness (I-DA)
WARNING
Failure to follow the warnings and instructions
for proper use of the I-DA
system could result in serious injury or
death.
The I-DA system is only a warning to
inform the driver of a potential lack
of driver attention or drowsiness. It
will not steer the vehicle or prevent
loss of cont ...
Camera image signal circuit (rear view camera to
camera control
unit)(coupe)
Description
Rear view camera images are transmitted to the rear view camera control unit
using the camera image signal
circuits.
Diagnosis Procedure
1.CHECK CAMERA IMAGE SIGNAL CIRCUIT CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect rear view camera control unit connector and rear v ...
Door finisher
Exploded View
1. Mirror cover
2. Front door finisher
3. Step lamp lens
4. Rear door finisher
5. Step lamp/reflector lens (if equipped)
6. Arm rest finisher
7. Rear door power window switch finisher
8. Inside release handle
9. Inside release handle escutcheon
9. Inside release handle esc ...