Nissan Altima (L32) 2007-2012 Service Manual: Illumination
Removal and Installation
TRUNK ROOM LAMP
Removal
1. Disconnect the negative battery terminal.
2. Release the tab (A), then swing open the lens.
3. Remove the bulb (3).
4. Release the tab (B), then pull trunk room lamp (2) away from
body opening.
5. Disconnect the connector (1) and remove trunk room lamp.
Installation
Installation is in the reverse order of removal.
Bulb Replacement
1. Disconnect the negative battery terminal.
2. Release the tab (A), then swing open the lens.
3. Pull bulb (3) straight out to remove.
Removal and Installation
FRONT ROOM/MAP LAMP
NOTE:
For non-sunroof equipped vehicles, the front room/map lamp assembly is an
integral part of the headinlining
and repaired only as an assembly. R ...
Bulb Specifications
* Always check with the Parts Department for the latest parts information. ...
Other materials: Tachometer
5 inch (13 cm) Type A (if so equipped)
The tachometer indicates engine speed in
revolutions per minute (rpm).
Do not rev the engine into the red zone 1.
7 inch (18 cm) Type B (if so equipped)
CAUTION
When engine speed approaches the
red zone, shift to a higher gear or reduce
engine speed. Operati ...
Rear-facing child restraint installation
using the seat belts
WARNING
The three-point seat belt with Automatic
Locking Retractor (ALR) must be
used when installing a child restraint.
Failure to use the ALR mode will result
in the child restraint not being properly
secured. The restraint could tip over or
be loose and cause injury to a child in a
sudden stop o ...
Rear-facing child restraint installation
using LATCH
For additional information, see all Warnings
and Cautions in the "Child safety"
and "Child restraints" before installing
a child restraint.
Do not use the lower anchors if the combined
weight of the child and the child restraint
exceeds 65 lbs. (29.5 kg). If the combined
weight of the child and the ...