Nissan Altima 2007-2012 Service Manual: Front bumper
Removal and Installation
1. Front bumper supports
2. Front bumper reinforcement
3. Energy absorbing foam
4. Tow cover
5. Front grille
6. Engine under cover
7. Fog lamp finisher (if equipped)
8. Fog lamp (if equipped)
9. Front bumper fascia
REMOVAL
1. Remove the front fender protectors RH and LH. Refer to EXT-40, "Removal and Installation".
2. Remove the engine under cover.
3. Remove the front grille. Refer to EXT-38, "Removal and Installation".
4. Remove the fog lamp if equipped. Refer to EXL-256, "Removal and Installation".
5. Remove the front bumper fascia clips and screws, then remove the front bumper fascia.
6. Remove the front energy absorbing foam.
7. Remove the front bumper reinforcement.
8. Remove the front bumper supports.
INSTALLATION
Installation is in the reverse order of removal.
Rear bumper
Removal and Installation 1. Rear bumper supports 2. Rear bumper reinforcement 3. Energy absorbing foam 4. Splash shield LH 5. Rear bumper fascia 6. Splash shield RH REMOVAL 1. Remove the L ...Other materials:
Subwoofer (coupe)
Description
The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker
amp. amplifies the audio
signals before sending them to the subwoofers using the audio signal circuits.
Diagnosis Procedure
1.HARNESS CHECK
1. Disconnect BOSE speaker amp. connector B122 and suspect
re ...
Changing engine coolant
A NISSAN dealer can change the engine coolant.
The service procedure can be found in the
NISSAN Service Manual.
Improper servicing can result in reduced
heater performance and engine overheating.
WARNING
● To avoid the danger of being scalded,
never change the coolant when the engin ...
Control device
Exploded View
1. Control lever knob
2. Lock pin
3. Knob cover
4. Control device selector plate
5. Control device assembly
Removal and Installation
REMOVAL
1. Remove the center console assembly. Refer to IP-18, "Disassembly and
Assembly".
2. Disconnect the control cable from ...