Nissan Altima (L32) 2007-2012 Service Manual: Rear spoiler
Removal and Installation
1. Rear spoiler assembly
2. High mounted stop lamp harness
3. Gasket
A. Nuts
Removal
1. Remove trunk lid finisher (if equipped). Refer to INT-23, "Removal and Installation".
2. Disconnect high mounted stop lamp connector.
3. Using a trim stick, carefully release the clips and pry foam tape free from trunk lid surface.
CAUTION: Use care not to damage painted surfaces during removal of, or releasing adhesive backed foam tapes.
4. Release the high mounted stop lamp harness grommet from trunk lid, then remove rear spoiler.
Installation
Installation is in the reverse order of removal.
NOTE: • Before installing rear spoiler, clean the surface where it will be mounted with isopropyl alcohol or equivalent to degrease the surface.
• Before installing, be sure there are no gaps or waves in the foam tape where the surfaces meet.
• During installation, be sure grommet of high mounted stop lamp harness is fully seated into trunk lid opening prior to final rear air spoiler placement.
License lamp finisher
Removal and Installation 1. License lamp finisher REMOVAL 1. Remove the trunk lid finisher (if equipped). Refer to INT-22, "Exploded View". 2. Remove the license lamp finisher nuts ...Other materials:
Precaution
Supplemental Restraint System (SRS) "AIR BAG"
and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT
PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and front ...
Noise
Component Function Check
SYMPTOM: Noise
INSPECTION FLOW
*1 HAC-102, "Operational Check"
*2 EM-16, "Checking Drive Belts"
(QR25DE) or EM-121, "Checking
Drive Belts" (VQ35DE)
*3 HAC-159, "Performance Chart"
*4 HA-45, "Removal and Installation for
...
Forward-facing child restraint installation using LATCH
Refer to all Warnings and Cautions in the “Child
Safety” and “Child Restraint” sections before installing
a child restraint.
Follow these steps to install a forward-facing
child restraint using the LATCH system:
1. Position the child restraint on the seat. Always
follow the child res ...