Nissan Altima 2007-2012 Service Manual: Hazard switch
Removal and Installation
Removal
1. Remove the cluster lid C. Refer to IP-12, "Removal and Installation".
2. Remove CVT finisher or M/T finisher. Refer to TM-255, "Removal and Installation" or TM-21, "Removal and Installation".
3. Remove the hazard switch screws (A) and remove the hazard switch. (1).
Installation
Installation is in the reverse order of removal.
Lighting and turn signal switch
Removal and Installation Removal 1. Remove the spiral cable. Refer to SR-8, "Removal and Installation" 2. Disconnect the lighting and turn signal switch connector and remove the lighti ...Service data and specifications (SDS)
Headlamp *: Always check with the Parts Department for the latest parts information. Exterior Lamp *: Always check with the Parts Department for the latest parts information. ...Other materials:
B210C starter control relay
Description
Starter control relay, integrated in IPDM E/R, permits the starter relay
operation when in N or P position and
the steering is locked or unlocked. It is installed in parallel with the starter
relay.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210C is displayed with DTC U10 ...
On-vehicle repair
SUNROOF UNIT ASSEMBLY
Inspection
WIND DEFLECTOR
1. Open glass lid assembly fully.
2. Visually check for proper installation, damaged/deteriorated components, or
foreign objects within mechanism.
Correct as required for smooth operation.
3. Check for grease at the wind deflector arm ( ...
Regulatory Information
FCC Regulatory information
– CAUTION: To maintain compliance with
FCC’s RF exposure guidelines, use only the
supplied antenna. Unauthorized antenna,
modification, or attachments could damage
the transmitter and may violate FCC regulations.
– Operation is subject to the following two cond ...