Nissan Altima 2007-2012 Service Manual: Front grille
Removal and Installation
1. Front bumper fascia
2. Front grille
3. License plate bracket
4. Fog lamp finisher (if equipped)
5. Fog lamp (if equipped)
A. Clip C101
Removal
1. Remove the front fender protectors RH and LH. Refer to EXT-19, "Removal and Installation".
2. Remove the engine under cover.
3. Remove the RH and LH side under covers.
4. Remove the front bumper fascia clips and screws, then remove the front bumper fascia.
5. Remove the fog lamp if equipped. Refer to EXL-256, "Removal and Installation".
6. Release the grille tabs from the front bumper fascia and remove the front grille.
Installation
Installation is in the reverse order of removal.
Rear bumper
Removal and Installation 1. Rear bumper side brackets 2. Rear bumper supports 3. Rear bumper reinforcement 4. Rear energy absorbing foam 5. Rear bumper fascia A. C205 push pin REMOVAL 1. R ...Cowl top
Removal and Installation 1. Cowl top seal 2. Cowl top side trim covers 3. Cowl top foam blocks 4. Cowl top A. Clips REMOVAL 1. Remove both the RH and LH wiper arms. Refer to WW-116, "FRO ...Other materials:
Diagnosis system (BCM)
COMMON ITEM
Diagnosis Description
CONSULT-III performs the following functions via CAN communication with
BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for all sub system
selection items.
...
On-vehicle repair
POWER WINDOW MAIN SWITCH
Removal and Installation
REMOVAL
1. Remove the power window main switch finisher (2). Refer to
INT-12, "Removal and Installation".
2. Power window main switch (1) is removed from power window
main switch finisher (2) using a suitable tool (A).
CAUTION: ...
Symptom diagnosis
SQUEAK AND RATTLE TROUBLE DIAGNOSES
Work Flow
CUSTOMER INTERVIEW
Interview the customer if possible, to determine the conditions that exist
when the noise occurs. Use the Diagnostic
Worksheet during the interview to document the facts and conditions when the
noise occurs and any
customer ...