Nissan Altima 2007-2012 Service Manual: Lan system can system (type 2)

COMPONENT DIAGNOSIS

Can communication circuit
Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connect ...

Main line between DLC And ABS Circuit
Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and co ...

Other materials:

Harness connector
Description HARNESS CONNECTOR (TAB-LOCKING TYPE) • The tab-locking type connectors help prevent accidental looseness or disconnection. • The tab-locking type connectors are disconnected by pushing or lifting the locking tab(s). Refer to the figure below. Refer to the next page for d ...

Front tweeter
Removal and Installation REMOVAL 1. Remove the front pillar finisher. Refer to INT-15, "Removal and Installation" (coupe) and INT-36, "Removal and Installation" (sedan). 2. Remove tweeter speaker grille. Refer to IP-12, "Removal and Installation". 3. Remove t ...

B26e1 no reception of engine status signal
Description BCM receives the engine status signal from ECM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26E1 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-433, "DTC Logic". • If DTC B26E1 is displayed w ...