Nissan Altima 2007-2012 Service Manual: Exterior lighting system
- Basic inspection
- Function diagnosis
- Headlamp (xenon type)
- Headlamp (halogen type)
- Daytime running light system
- Auto light system
- Front fog lamp
- Turn signal and hazard warning lamps
- Parking, license plate and tail lamps
- Combination switch reading system
- Diagnosis system (BCM)
- Diagnosis system (IPDM E/R)
- Component diagnosis
- Power supply and ground circuit
- Headlamp (HI) circuit
- Headlamp (LO) circuit
- Front fog lamp circuit
- Parking lamp circuit
- Turn signal lamp circuit
- Optical sensor
- Headlamp (halogen)
- Headlamp (xenon)
- Daytime running light system
- Auto light system
- Front fog lamp system
- Turn signal and hazard warning lamp system
- Parking, license plate and tail lamps system
- Stop lamp
- Back-up lamp
- ECU diagnosis
- Symptom diagnosis
- Exterior lighting system symptoms
- Normal operating condition
- Both side headlamps do not switch to high beam
- Both side headlamps (LO) are not turned on
- Parking, license plate and tail lamps are not turned on
- Both side front fog lamps are not turned on
- Precaution
- On-vehicle maintenance
- On-vehicle repair
- Headlamp
- Front fog lamp
- Stop lamp
- Back-up lamp
- License plate lamp
- Rear combination lamp
- Lighting and turn signal switch
- Hazard switch
- Service data and specifications (SDS)
Disassembly and assembly
DOOR MIRROR Exploded View 1. Door mirror cover 2. Mirror housing assembly 3. Mirror glass and holder Disassembly 1. Turn the mirror glass surface upward. 2. Apply a protective tape (A) to ...Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1.INTERVIEW FOR MALFUNCTION Find out what the customer's concerns are. >> GO TO 2 2.SYMPTOM CHECK Verify the s ...Other materials:
B2601 shift position
Description
BCM confirms the shift position with the following 2 signals.
• CVT selector lever
• P position signal from IPDM E/R (CAN)
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2601 is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
SEC-36 ...
Reverse signal circuit
Description
A reverse signal is supplied from the back-up lamp relay to the rear view
camera control unit. When this signal
is received, the display shows a view to the rear of the vehicle.
Diagnosis Procedure
1.BACK-UP LAMP INSPECTION
1. Turn ignition switch ON.
2. Shift selector lever t ...
Roof side molding
Removal and Installation
1. Body side outer panel
2. Windshield
3. Roof
REMOVAL
1. Lift and twist the roof side molding up from the rear edge.
2. Disconnect the roof side molding from the clips, and remove the roof side
molding.
INSTALLATION
Installation is in the reverse order of ...