Nissan Altima 2007-2012 Service Manual: Front washer nozzle

 Removal and Installation

REMOVAL

1. Remove the cowl top cover For Sedan Refer to EXT-39, "Removal and Installation". For Coupe Refer to EXT-18, "Removal and Installation" 2. Push washer nozzle tab (A), to release the washer nozzle (1) from the cowl top cover, then disconnect the washer nozzle hose (2).

INSTALLATION

1. Installation is in the reverse order of removal.

2. Adjust nozzle spray location. Refer to WW-119, "FRONT WASHER NOZZLE : Adjustment".

Adjustment

Adjust spray positions to match the positions as shown.

*1: Spray positions are aiming targets, heights are allowable spray patterns above the target points.

Insert a suitable tool (A) into the nozzle hole (B) and move up/down and left/right to adjust the spray position of the nozzle (1).

    Washer tube
    Layout 1. Washer nozzle LH 2. Washer nozzle hose LH 3. Washer nozzle RH 4. Washer nozzle hose RH 5. Y-tube connector 6. Clip 7. Washer tank hose 8. Washer tank A. Tube connectors ...

    Washer tank
    Removal and Installation REMOVAL 1. Remove the washer tank filler tube (1). 2. Remove engine under cover. 3. Position the RH fender protector back. For Sedan Refer to EXT-40, "Removal a ...

    Other materials:

    On-vehicle repair
    ACCELERATOR CONTROL SYSTEM Exploded View 1. Accelerator pedal and accelerator position sensor assembly. 2. Locating pins Removal and Installation REMOVAL 1. Disconnect the battery negative terminal. 2. Disconnect the accelerator position sensor electrical connector. 3. Remove the t ...

    B2603 shift position status
    Description BCM confirms the shift position with the following 2 signals. • CVT selector lever • P/N position switch DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2603 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-36, "DTC Logic& ...

    Mode door motor
    Removal and Installation REMOVAL 1. Remove the combination meter. Refer to MWI-176, "Removal and Installation". 2. Remove the BCM (2). Refer to BCS-96, "Removal and Installation". NOTE: The illustration is shown with the heater and cooling unit assembly out of the ve ...