Nissan Altima 2007-2012 Service Manual: On-vehicle maintenance

Function diagnosis
LUBRICATION SYSTEM Lubrication Circuit Schematic ...

Engine oil
Inspection OIL LEVEL NOTE: • Before starting the engine, check the oil level. If the engine is already started, stop it and allow 10 minutes before checking. • Check that the oil leve ...

Other materials:

P0447 Evap canister vent control valve
Description The EVAP canister vent control valve is located on the EVAP canister and is used to seal the canister vent. This solenoid valve responds to signals from the ECM. When the ECM sends an ON signal, the coil in the solenoid valve is energized. A plunger will then move to seal the ca ...

Mode door motor
Removal and Installation REMOVAL 1. Remove the combination meter. Refer to MWI-176, "Removal and Installation". 2. Remove the BCM (2). Refer to BCS-96, "Removal and Installation". NOTE: The illustration is shown with the heater and cooling unit assembly out of the ve ...

The fuel gauge pointer does not move
Description Fuel gauge needle will not move from a certain position. Diagnosis Procedure 1.CHECK COMBINATION METER INPUT SIGNAL 1. Select “METER/M&A” on CONSULT-III. 2. Using “FUEL METER” of “DATA MONITOR”, compare the monitor value with the fuel gauge rea ...