Nissan Altima 2007-2012 Service Manual: On-vehicle repair

GENERATOR

Removal and Installation

QR25DE

1.-2. Tightening order


1.-2. Tightening order

3. Generator

4. B terminal nut

5. Generator bracket bolts

6. Generator bracket

Removal


Removal

1. Disconnect the battery negative terminal. Refer to PG-68, "Removal and Installation" (Coupe models) or PG-139, "Removal and Installation" (Sedan models).

2. Remove engine side undercover using power tools.

3. Remove drive belt. Refer to EM-16, "Removal and Installation".

4. Remove

    Preparation
    Special Service Tool The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here. Commercial Service Tool ...

    Other materials:

    Passenger compartment
    Fusible links If the electrical equipment does not operate and fuses are in good condition, check the fusible links. If any of these fusible links are melted, replace with only Genuine NISSAN parts. CAUTION Never use a fuse of a higher or lower amperage rating than specified on the fuse bo ...

    Precautions in repairing high strength steel
    High Strength Steel (HSS) High strength steel is used for body panels in order to reduce vehicle weight. Accordingly, precautions in repairing automotive bodies made of high strength steel are described below: SP130 is the most commonly used HSS. Read the following precautions when re ...

    Multiport fuel injection system
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: This sensor is not used to control the engine system under normal conditions. *2: This signal is sent to the ECM through CAN communication line. *3: ECM determines the start signal status by the signals of engine speed and ...