Nissan Altima 2007-2012 Service Manual: B2618 BCM

Description

BCM controls the various electrical components and simultaneously supplies power according to the power supply position.

BCM checks the power supply position internally.

DTC Logic

DTC DETECTION LOGIC

NOTE: • If DTC B2618 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to PCS-58, "DTC Logic".

• If DTC B2618 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to PCS-59, "DTC Logic".

DTC CONFIRMATION PROCEDURE

1. PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON under the following conditions, and wait for at least 1 second.

- CVT selector lever is in the P or N position

- Release brake pedal

2. Check “Self diagnostic result” with CONSULT-III.

Is DTC detected? YES >> Go to PCS-74, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1. INSPECTION START

1. Turn ignition switch ON.

2. Select “Self diagnostic result” mode with CONSULT-III.

3. Touch “ERASE”.

4. Perform DTC Confirmation Procedure.

See PCS-74, "DTC Logic".

Is the 1st trip DTC B2618 displayed again? YES >> Replace BCM. Refer to BCS-96, "Removal and Installation".

NO >> Inspection End.

    B2616 ignition relay circuit
    Description BCM controls the various electrical components and simultaneously supplies power according to the power supply position. BCM checks the power supply position internally. DTC Logic ...

    B261A push-button ignition switch
    Description BCM transmits the change in the power supply position with the push-button ignition switch to IPDM E/R via the CAN communication line. IPDM E/R transmits the power supply position sta ...

    Other materials:

    Hands free phone system (coupe)
    System Diagram System Description Refer to the owner's manual for Bluetooth telephone system operating instructions. NOTE: Cellular telephones must have their wireless connection set up (paired) before using the Bluetooth telephone system. Bluetooth telephone system allows users who ...

    Power supply and ground circuit for front air control
    Description FRONT AIR CONTROL The front air control has a built-in microcomputer which processes information sent from temperature control dial and various switches needed for air conditioner operation. The air mix door motor, mode door motor, intake door motor, blower motor and compressor are ...

    Can communication circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connectors on CAN communication system. 4. Check terminals and connectors for damage, bend and loose con ...