Nissan Altima 2007-2012 Service Manual: Passenger side door mirror defogger

Description

Heats the heating wire with the power supply from the rear window defogger relay to prevent the door mirror from fogging up.

Component Function Check

1.CHECK DOOR MIRROR DEFOGGER RH

Check that the heating wire of door mirror defogger RH is heated when turning the rear window defogger switch ON.

Is the inspection result normal? YES >> Door mirror defogger RH is OK.

NO >> Refer to DEF-17, "Diagnosis Procedure".

Diagnosis Procedure

1. CHECK POWER SUPPLY CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect door mirror RH.

3. Turn ignition switch ON.

4. Check voltage between door mirror RH connector and ground.


Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace harness.

2. CHECK GROUND CIRCUIT

1. Turn ignition switch OFF.

2. Check continuity between door mirror RH connector and ground.


Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 3

NO >> Repair or replace harness.

3. CHECK PASSENGER SIDE DOOR MIRROR DEFOGGER

Check door mirror defogger RH.

Refer to DEF-18, "Component Inspection".

Is the inspection result normal? YES >> GO TO 4

NO >> Replace door mirror RH. Refer to MIR-19, "Removal and Installation".

4. CHECK INTERMITTENT INCIDENT

Check intermittent incident.

Refer to GI-42, "Intermittent Incident".

Is the inspection result normal? YES >> Check the following.

    Driver side door mirror defogger
    Description Heats the heating wire with the power supply from the rear window defogger relay to prevent the door mirror from fogging up. Component Function Check 1. CHECK DOOR MIRROR DEFOGGER ...

    ECU diagnosis
    BCM (BODY CONTROL MODULE) Reference Value VALUES ON THE DIAGNOSIS TOOL Terminal Layout Physical Values 1: Sedan only 2: With LH front window ant ...

    Other materials:

    Self-diagnosis function
    Diagnosis Description SELF-DIAGNOSIS SYSTEM The self-diagnosis system is built into the front air control to quickly locate the cause of malfunctions. SELF-DIAGNOSIS FUNCTION The self-diagnosis system diagnoses sensors, door motors, blower motor, etc. by system line. Refer to applicable se ...

    Additional service when replacing control unit
     Description When replacing ECM, the following procedure must be performed.  Special Repair Requirement 1.PERFORM INITIALIZATION OF NVIS (NATS) SYSTEM AND REGISTRATION OF ALL NVIS (NATS) IGNITION KEY IDS Refer to SEC-15, "ECM RE-COMMUNICATING FUNCTION : Special Repair Requireme ...

    Wiring Diagram - Intelligent key system/ engine start function
    Wiring Diagram - VEHICLE SECURITY SYSTEM Wiring Diagram - NVIS Fail Safe DTC Inspection Priority Chart If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart. ...