Nissan Altima 2007-2012 Service Manual: Front fog lamp
Bulb Replacement
REMOVAL
The fog lamp is a semi-sealed beam type which uses a replaceable halogen bulb.
CAUTION: • Do not touch the glass of bulb directly by hand. Keep grease and other oily substances away from it.
Do not touch bulb by hand while it is lit or right after being turned off. Burning may result.
• Do not leave bulb out of fog lamp reflector for a long time because dust, moisture smoke, etc. may affect the performance of fog lamp. When replacing bulb, be sure to replace it with new one. 1. Position the front fender protector aside. Refer to EXT-19, "Removal and Installation".
2. Disconnect the fog lamp electrical connector.
3. Turn the fog lamp bulb counterclockwise to remove it.
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
REMOVAL
The fog lamp is a semi-sealed beam type which uses a replaceable halogen bulb.
CAUTION: • Do not leave fog lamp assembly without bulb for a long period of time. Dust, moisture, smoke, etc.
entering the fog lamp body may affect the performance. Remove the bulb from the headlamp assembly just before replacement bulb is installed.
• Grasp only the plastic base when handling the bulb. Never touch the glass envelope. Touching the glass could significantly affect the bulb life and/or fog lamp performance. 1. Remove inner splash shield.
2. Position the fender protector aside. Refer to EXT-19, "Removal and Installation".
3. Disconnect the fog lamp electrical connector.
4. Remove bolt from top of fog lamp.
5. Remove fog lamp.
INSTALLATION
Installation is in the reverse order of removal.
Check fog lamp aiming adjustment. Refer to EXL-252, "Aiming Adjustment".
Headlamp
Bulb Replacement HEADLAMP CAUTION: • Do not touch the glass of bulb directly by hand. Keep grease and other oily substances away from bulb. Do not touch bulb by hand while it is lit or right a ...Stop lamp
Bulb Replacement Removal 1. Remove rear combination lamp. Refer to EXL-257, "Removal and Installation". 2. Turn bulb socket counterclockwise to unlock and remove from combination lam ...Other materials:
P1554 Battery current sensor
Description
The power generation voltage variable control enables fuel consumption to be
decreased by reducing the
engine load which is caused by the power generation of the generator. The
battery current sensor is installed
to the battery cable at the negative terminal. The sensor measures t ...
Conditions the remote start will not work
The remote start will not operate if any of the
following conditions are present:
● The ignition switch is placed in the ON position.
● The hood is not securely closed.
● The hazard warning lights are on.
● The I–Key Indicator Light remains
solid in the vehicle inform ...
M&A branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the combination meter for damage, bend
and loose connection
(unit side and connector side).
...