Nissan Altima (L32) 2007-2012 Service Manual ≻ Exterior sedan ≻ On-vehicle repair ≻ License lamp finisher

Nissan Altima (L32) 2007-2012 Service Manual: License lamp finisher

Removal and Installation

1. License lamp finisher

REMOVAL

1. Remove the trunk lid finisher (if equipped). Refer to INT-22, "Exploded View".

2. Remove the license lamp finisher nuts.

3. Remove license lamp finisher by pulling toward the rear, then disconnect the trunk request switch connector.

INSTALLATION

Installation is in the reverse order of removal.

Roof side molding

Removal and Installation 1. Body side outer panel 2. Windshield 2. Windshield REMOVAL 1. Lift and twist the roof side molding up from the rear edge. 2. Disconnect the roof side molding ...

Rear spoiler

Removal and Installation 1. Rear spoiler assembly 2. High mounted stop lamp harness 3. Gasket A. Nuts Removal 1. Remove trunk lid finisher (if equipped). Refer to INT-23, "Removal and ...

Other materials:

Front power seat adjustment (if so equipped)
Operating tips The power seat motor has an auto-reset overload protection circuit. If the motor stops during operation, wait 30 seconds then reactivate the switch. Do not operate the power seat switch for a long period of time when the engine is off. This will discharge the battery. For add ...

Engine compartment check locations
2.0L 4 cylinder (KR20DDET engine model) Engine coolant reservoir Drive belt location Engine oil filler cap Brake fluid reservoir Battery Fuse/Fusible link box Air cleaner Radiator cap Engine oil dipstick Windshield-washer fluid reservoir Refer to the page number indicated in parenth ...

Resetting the drive computer
The drive computer is divided across three screens: Speed Trip Distance & Time Fuel Economy 1. Press the or buttons until the desired drive computer screen is displayed. 2. Press the OK button to bring up the drive computer Reset menu. 3. Use the or to select the desired option. Then press ...