Nissan Altima 2007-2012 Service Manual: Power window retained power operation does not operate properly

Diagnosis Procedure

1. CHECK FRONT DOOR SWITCH

Check front door switch.

Refer to PWC-326, "Component Function Check".

Is the inspection result normal? YES >> Inspection end.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Auto operation does not operate but manual operates normally (passenger side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement&quo ...

    Does not operate by key cylinder switch
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement&quo ...

    Other materials:

    Malfunction indicator lamp
    Description The Malfunction Indicator Lamp (MIL) is located on the combination meter. The MIL will light up when the ignition switch is turned ON without the engine running. This is a bulb check. When the engine is started, the MIL should go off. If the MIL remains on, the on board diagno ...

    Air conditioning cut control
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: This signal is sent to the ECM through CAN communication line. *2: ECM determines the start signal status by the signals of engine speed and battery voltage. SYSTEM DESCRIPTION This system improves engine operation when th ...

    On-vehicle rep
    BCM (BODY CONTROL MODULE) Removal and Installation REMOVAL CAUTION: Before replacing BCM, perform "READ CONFIGURATION" to save or print current vehicle specification. Refer to BCS-5, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description". 1. Remove the combinati ...