Nissan Altima (L32) 2007-2012 Service Manual: Back-up lamp
Bulb Replacement
Removal
1. Remove the rear combination lamp. Refer to EXL-260, "Removal and Installation".
2. Turn back-up lamp bulb socket counterclockwise to unlock and remove.
3. Pull back-up lamp bulb from socket to remove.
Installation
Installation is in the reverse order of removal.
Stop lamp
Bulb Replacement Removal 1. Remove rear combination lamp. Refer to EXL-257, "Removal and Installation". 2. Turn bulb socket counterclockwise to unlock and remove from combination lam ...License plate lamp
Bulb Replacement REMOVAL 1. Position trunk lid finisher aside. 2. Turn license plate lamp bulb socket counterclockwise to unlock and remove. 3. Pull license plate lamp bulb to remove from so ...Other materials:
B210A steering lock condition switch
Description
There are 2 switches in the electronic steering column lock. IPDM E/R
compares those 2 switches conditions
to judge the present steering status and transmit the result to BCM via CAN
communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210A is displayed with DTC U100 ...
Seats
WARNING
● Do not ride in a moving vehicle when
the seatback is reclined. This can be
dangerous. The shoulder belt will not
be against your body. In an accident,
you could be thrown into it and receive
neck or other serious injuries. You
could also slide under the lap belt and
receive ...
Main line between DLC and ABS circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose
connection (connector side
and harness side).
- Harness co ...