Nissan Altima 2007-2012 Service Manual: The oil pressure warning lamp does not turn off

Description

The oil pressure warning lamp remains illuminated while the engine is running (normal oil pressure).

Diagnosis Procedure

1.CHECK OIL PRESSURE WARNING LAMP

Perform IPDM E/R auto active test. Refer to PCS-14, "Diagnosis Description".

Is oil pressure warning lamp illuminated? YES >> GO TO 2

NO >> Replace combination meter. Refer to MWI-176, "Removal and Installation".

2.CHECK IPDM E/R OUTPUT VOLTAGE

1. Turn ignition switch OFF.

2. Disconnect the oil pressure switch connector.

3. Turn ignition switch ON.

4. Check voltage between the oil pressure switch harness connector F41 terminal 1 and ground.

Is the inspection result normal? YES >> GO TO 3

NO >> GO TO 4

3.CHECK OIL PRESSURE SWITCH

Perform a unit check for the oil pressure switch. Refer to MWI-48, "Component Inspection".

Is the inspection result normal? YES >> Replace IPDM E/R. Refer to PCS-48, "Removal and Installation".

NO >> Replace oil pressure switch.

4.CHECK OIL PRESSURE SWITCH SIGNAL CIRCUIT

Check the oil pressure switch signal circuit. Refer to MWI-48, "Diagnosis Procedure".

Is the inspection result normal? YES >> Replace IPDM E/R. Refer to PCS-48, "Removal and Installation".

NO >> Repair harness or connector.

    The oil pressure warning lamp does not turn on
    Description The oil pressure warning lamp stays off when the ignition switch is turned ON. Diagnosis Procedure 1.CHECK OIL PRESSURE WARNING LAMP Perform IPDM E/R auto active test. Refer to PCS ...

    The parking brake release warning continues displaying, or does not display
    Description • The parking brake warning is displayed while driving the vehicle even though the parking brake is released. • The parking brake warning is not displayed even though driving th ...

    Other materials:

    Inspection and adjustment
    ECM RE-COMMUNICATING FUNCTION Description Performing following procedure can automatically perform re-communication of ECM and BCM, but only when the ECM has been replaced with a new one (*1). *1: New one means an ECM which has never been energized on-board. (In this step, initialization ...

    P2A00 A/F sensor 1
    Description The air fuel ratio (A/F) sensor 1 is a planar one-cell limit current sensor. The sensor element of the A/F sensor 1 is composed an electrode layer, which transports ions. It has a heater in the element. The sensor is capable of precise measurement = 1, but also in the lean and r ...

    HomeLink® universal transceiver (if so equipped)
    The HomeLink® Universal Transceiver provides a convenient way to consolidate the functions of up to three individual hand-held transmitters into one built-in device. HomeLink® Universal Transceiver: ● Will operate most Radio Frequency (RF) devices such as garage doors, gates, home a ...