Nissan Altima 2007-2012 Service Manual: Push button ignition switch

Removal and Installation

REMOVAL

1. Remove the cluster lid A assembly. Refer to IP-12, "Removal and Installation".

2. Release the pawls (A) and remove the push-button ignition switch (1) from cluster lid A.

INSTALLATION


INSTALLATION

Installation is in the reverse order of removal.

    BCM (Body control module)
    Removal and Installation For removal and installation of the BCM refer to BCS-96, "Removal and Installation". ...

    Other materials:

    Blower unit
    Removal and Installation COMPONENTS 1. Heater and cooling unit 2. Blower unit Front REMOVAL 1. Remove the heater and cooling unit assembly. Refer to VTL-12, "Removal and Installation". 2. Disconnect the blower motor connector. 3. Remove the screws from the blower unit, the ...

    ECM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). - ECM - Harnes ...

    Passenger compartment
    Fusible links If the electrical equipment does not operate and fuses are in good condition, check the fusible links. If any of these fusible links are melted, replace with only Genuine NISSAN parts. CAUTION Never use a fuse of a higher or lower amperage rating than specified on the fuse bo ...