Nissan Altima 2007-2012 Service Manual: Rear bumper

Removal and Installation

1. Rear bumper supports


1. Rear bumper supports

2. Rear bumper reinforcement

3. Energy absorbing foam

4. Splash shield LH

5. Rear bumper fascia

6. Splash shield RH

REMOVAL


REMOVAL

1. Remove the LH and RH rear combination lamps. Refer to EXL-260, "Removal and Installation".

2. Remove both the rear wheels and tires. Refer to WT-66, "Adjustment".

3. Remove the LH and RH splash shields.

4. Remove the rear bumper fascia clips and screws, then remove the rear bumper fascia.

5. Remove the rear energy absorbing foam.

6. Remove the rear bumper reinforcement.

7. Remove the rear bumper supports.

INSTALLATION

Installation is in the reverse order of removal.

    Front bumper
    Removal and Installation 1. Front bumper supports 2. Front bumper reinforcement 3. Energy absorbing foam 4. Tow cover 5. Front grille 6. Engine under cover 7. Fog lamp finisher (if equipped) ...

    Front grille
    Removal and Installation 1. Front grille 2. Bumper fascia FRONT GRILLE Removal 1. Remove the front grille clips. 2. Release the grille tabs from the front bumper fascia, then remove the ...

    Other materials:

    U1001 Can comm circuit
    Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each c ...

    M&A branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the combination meter for damage, bend and loose connection (unit side and connector side). ...

     button
    To change the display brightness, press the button. Pressing the button again will change the display to the day or the night display. If no operation is performed within 5 seconds, the display will return to the previous display. Press and hold the button for more than two seconds to ...