Nissan Altima 2007-2012 Service Manual: Bluetooth control unit
Diagnosis Procedure
1.CHECK FUSE
Check that the following fuses of the Bluetooth control unit are not blown.
Are the fuses OK? YES >> GO TO 2
NO >> Be sure to eliminate cause of malfunction before installing new fuse.
2.CHECK POWER SUPPLY CIRCUIT
Check voltage between Bluetooth control unit harness connector and ground.
Are the voltage results as specified? YES >> GO TO 3
NO >> Check harness between Bluetooth control unit and fuse.
3.CHECK GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect Bluetooth control unit connector B126.
3. Check continuity between Bluetooth control unit harness connector and ground.
Does continuity exist? YES >> Inspection End.
NO >> Repair harness or connector.
Satellite radio tuner
Diagnosis Procedure 1.CHECK FUSES Check that the following fuses are not blown. Are the fuses OK? YES >> GO TO 2 NO >> If fuse is blown, be sure to eliminate cause of malfunction be ...Microphone
Diagnosis Procedure 1.CHECK POWER SUPPLY CIRCUIT (MICROPHONE SIDE) Check voltage between microphone harness connector and ground. Is proper voltage present? YES >> GO TO 4 NO >> G ...Other materials:
Control cable
Exploded View
1. Control lever
2. Control device assembly
3. Control cable socket
4. Retainer grommet
5. Control cable
6. Bracket
7. Lock plate
8. Manual lever
Removal and Installation
REMOVAL
1. Shift control lever to "P".
2. Remove the air filter assembly. Refer to EM-25 ...
Air cleaner and air duct
Removal and Installation
1. Air duct hose
2. Front air duct
3. Air cleaner mounting bracket
4. Air cleaner assembly
5. Mass air flow sen
A. To electric throttle control actuator
REMOVAL
1. Remove front air duct.
2. Disconnect the air duct hose clamps at the electric throttle control act ...
Body side trim
Exploded View
1. Front pillar finisher
2. Dash side lower finisher
3. Front kicking plate
4. Front sill cover
5. Center pillar lower finisher
6. Rear sill cover
7. Rear kicking plate
8. Rear body side welt
9. Rear pillar finisher
10. Screw cover
11. Center pillar upper finisher
12. Fro ...