Nissan Altima 2007-2012 Service Manual: Diagnosis system (meter)

Diagnosis Description

SELF-DIAGNOSIS MODE

• Odo/trip meter and information display segment operation can be checked in self-diagnosis mode.

• Meters/gauges can be checked in self-diagnosis mode.

OPERATION PROCEDURE

1. Turn the ignition switch OFF.

2. While pushing the odo/trip meter switch, turn the ignition switch ON again.

3. Push the odo/trip meter switch at least 3 times within 7 seconds after the ignition switch is turned ON.

4. The unified meter control unit is turned to self-diagnosis mode.

• All the segments on the odo/trip meter illuminate.

• Dots in all segments of information display LCD (1) flash alternately.

NOTE: If any of the segments are not displayed, replace the combination meter. Refer to MWI-176, "Removal and Installation".

5. Push the odo/trip meter switch. Each meter/gauge should indicate as shown in the figure.

CONSULT-III Function (METER/M&A)

CONSULT-III can display each diagnostic item using the diagnostic test modes shown following.

SELF-DIAG RESULTS

Display Item List

Refer to MWI-95, "DTC Index".

DATA MONITOR

Display Item List

NOTE: Some items are not available due to vehicle specification.

*: The monitor will indicate “OFF” even though the brake warning lamp is on if either of the following conditions exist.

• The parking brake is engaged

• The brake fluid level is low

    Compass
    Description DESCRIPTION With the ignition switch in the ON position, and the mode (N) switch ON, the compass display will indicate the direction the vehicle is heading. Vehicle direction is dis ...

    Component diagnosis
    ...

    Other materials:

    Multiport fuel injection system
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: This sensor is not used to control the engine system under normal conditions. *2: This signal is sent to the ECM through CAN communication line. *3: ECM determines the start signal status by the signals of engine speed and ...

    Passenger side
    Description Detects condition of the front power window motor RH operation and transmits to power window and door lock/unlock switch RH as pulse signal. Component Function Check 1.CHECK ENCODER OPERATION Does front door glass RH perform AUTO open/close operation normally when operating powe ...

    B260b steering lock unit
    Description The steering lock unit performs the check by itself according to the steering status. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Press the push-button ignition switch, when steering is locked. 2. Check “Self diagnostic ...