Nissan Altima 2007-2012 Service Manual: Rear rh side power window alone does not operate

Diagnosis Procedure

1. CHECK REAR POWER WINDOW SWITCH RH

Check rear power winodw switch RH.

Refer to PWC-310, "REAR POWER WINDOW SWITCH : Component Function Check".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning parts.

2. CHECK REAR POWER WINDOW MOTOR RH

Check rear power window motor RH.

Refer to PWC-318, "REAR RH : Component Function Check".

Is the inspection result normal? YES >> Inspection end.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Rear lh side power window alone does not operate
    Diagnosis Procedure 1. CHECK REAR POWER WINDOW SWITCH LH Check rear power window switch LH. Refer to PWC-310, "REAR POWER WINDOW SWITCH : Component Function Check". Is th e inspectio ...

    Anti-pinch system does not operate normally (driver side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement&quo ...

    Other materials:

    Air conditioner operation
    Start the engine, turn the fan control dial to the desired position, and press the button to activate the air conditioner. When the air conditioner is on, cooling and dehumidifying functions are added to the heater operation. The air conditioner cooling function operates only when the engin ...

    Rear bumper
    Removal and Installation 1. Rear bumper supports 2. Rear bumper reinforcement 3. Energy absorbing foam 4. Splash shield LH 5. Rear bumper fascia 6. Splash shield RH REMOVAL 1. Remove the LH and RH rear combination lamps. Refer to EXL-260, "Removal and Installation". 2. Rem ...

    P0826 manual mode switch
    Description Manual mode switch is installed in CVT control device. The manual mode switch sends shift up and shift down switch signals to TCM. TCM sends the switch signals to combination meter via CAN communication line. Then manual mode switch position is indicated on the CVT position ind ...