Nissan Altima 2007-2012 Service Manual: Roof

On-vehicle repair
POWER WINDOW MAIN SWITCH Removal and Installation REMOVAL 1. Remove the power window main switch finisher (2). Refer to INT-34, "Removal and Installation". 2. Power window main swit ...

Other materials:

P0102, P0103 MAF sensor
Description The mass air flow sensor (1) is placed in the stream of intake air. It measures the intake flow rate by measuring a part of the entire intake flow. The mass air flow sensor controls the temperature of the hot wire to a certain amount. The heat generated by the hot wire is reduced a ...

Fuel pressure
Inspection FUEL PRESSURE RELEASE 1. Turn ignition switch ON. 2. Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode with CONSULT-III. 3. Start engine. 4. After engine stalls, crank it two or three times to release all fuel pressure. 5. Turn ignition switch OFF. 1. Rem ...

Electric ignition system
System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: This signal is sent to the ECM through CAN communication line. *2: ECM determines the start signal status by the signals of engine speed and battery voltage. SYSTEM DESCRIPTION Firing order: 1 - 3 - 4 - 2 The ignition tim ...