Nissan Altima 2007-2012 Service Manual: BCM (Body control module)

Reference Value

VALUES ON THE DIAGNOSIS TOOL

Terminal Layout

Physical Values

1: Sedan only

2: With LH front window anti-pinch

3: With LH and RH front window anti-pinch

4: With Intelligent Key

5: Without Intelligent Key

Wiring Diagram-Coupe

Wiring Diagram-Sedan

Fail Safe

DTC Inspection Priority Chart

If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart.

DTC Index

NOTE:

Details of time display

• CRNT: Displays when there is a malfunction now or after returning to the normal condition until turning ignition switch OFF → ON again.

• 1 - 39: Displayed if any previous malfunction is present when current condition is normal. It increases like 1 → 2 → 3...38 → 39 after returning to the normal condition whenever ignition switch OFF → ON. The counter remains at 39 even if the number of cycles exceeds it. It is counted from 1 again when turning ignition switch OFF → ON after returning to the normal condition if the malfunction is detected again.

    Combination meter
    Reference Value TERMINAL LAYOUT PHYSICAL VALUES Wiring Diagram - Coupe Wiring Diagram - Sedan Fail Safe The combination ...

    IPDM E/R (Intelligent power distribution module engine room)
    Reference Value VALUES ON THE DIAGNOSIS TOOL TERMINAL LAYOUT PHYSICAL VALUES Wiring Diagram — Coupe Wiring Diagram — Sedan Fail Safe CAN COMMUNICA ...

    Other materials:

    CVT system
    System Diagram Component Parts Location - Coupe 1. Control device assembly 2. Accelerator pedal position sensor 3. CVT unit harness connector 4. Primary speed sensor 5. Secondary speed sensor 6. PNP switch 7. TCM 8. Battery 9. Shift position indicator Manual mode indicator Component ...

    On-vehicle repair
    EVAP CANISTER Exploded View 1. EVAP control system pressure sensor 2. EVAP canister 3. O-ring 4. EVAP canister vent control valve 5. O-ring Removal and Installation REMOVAL 1. Lift up the vehicle. 2. Remove EVAP canister fixing bolt. 3. Remove EVAP canister. NOTE: The EVAP canis ...

    P0643 Sensor power supply
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. TESTING CONDITION: Before performing the following proced ...